Shawn
- Total activity 468
- Last activity
- Member since
- Following 0 users
- Followed by 4 users
- Votes 1
- Subscriptions 245
Articles
Recent activity by Shawn-
SR-955HPC Setup Guide
(Click Picture For Larger View) Band / VFO Switch Set to Band, Turn Frequency Knob to band 4 then set switch to the middle position Receiver Squelch Start with it all the way to the left Receiver...
-
HIC (Hi-Cut Filter) What and How to use it
HIC: This is the Hi-Cut Filter, once this function is enabled, the radiowill cut out high-frequency noise in the receiver circuit. Higher frequencies make up a good portion of what we often refer t...
-
HIC or Hi-Cut Filter
HIC: This is the Hi-Cut Filter, once this function is enabled, the radiowill cut out high-frequency noise in the receiver circuit. Higher frequencies make up a good portion of what we often refer t...
-
HIC Feature, what is it and what does it do?
HIC: This is the Hi-Cut Filter, once this function is enabled, the radiowill cut out high-frequency noise in the receiver circuit. Higher frequencies make up a good portion of what we often refer t...
-
Interference from LED Headlights on my vehicle
LED & HID lights can cause a tremendous amount of RF Interference. One fix to improve this is using a ferrite choke, sometimes called an RF choke. Both names refer to the same device. Ferrite bead...
-
Is it possible to program roger beep key up tones at the start of the transmission?
The radio does not have the option to play the beep when you key up. However, that is something we can add with a firmware upgrade. That upgrade is something you can do to existing radios, so it's ...
-
Mounting Bracket Side Knob Size
The mounting bracket side knobs that fit the SR-955HPC and SR-655HPC are: SR-655HPC----------5mm SR-955HPC----------5mm
-
How to use CTCSS with the SR-955HPC
Using the SR-955HPC with the CTCSS Module When you using the CTCSS board along with repeater offsets, the radio should be in VFO mode. Slide your switch so PRG is selected. The first option you wil...
-
Is there a battery that powers the lights that are inside the antenna?
No battery is used to power the antenna lighting, so you never have to worry about needing to replace it. It samples a small amount of voltage as it radiates through the antenna, and that is how th...
-
Does the variable power just set the dead key or adjust the power itself?
From the factory, the knob will control both the deadkey as well as the PEP power. Depending on if someone tunes the radio, and the modulation adjustment is turned up too high, the power knob will ...