Shawn
- Total activity 496
- Last activity
- Member since
- Following 0 users
- Followed by 4 users
- Votes 1
- Subscriptions 262
Articles
Recent activity by Shawn-
Diameter of Protective Boot for SR-A 10MM magnet mount
The diameter measures just a little over 4.75 inches, which means that it will fit perfectly with the SR-A10MM base and Wilson 1000 / 5000 magnetic mounts. In case you wish to obtain additional pie...
-
Should the rubber boot stay on when mounting the SR-A10MM to a vehicle roof?
Does the SR-A10 magnet mount "rubber boot" stay on or off when mounting to the metal roof of a vehicle? The SR-A10 magnet mount should always be used with its accompanying rubber boot when mountin...
-
Can you tune SWR on the radio?
The meter on the SR-955HPC can be used just like an external SWR meter. It will not lower the SWR; it only shows you what it is. You then take that information and decide if you need to raise or lo...
-
Do your radios work on GMRS channels?
Our radios operate on HF frequencies, and GMRS is on UHF. To answer your question, they will not work on GMRS frequencies.
-
Run time error '6': Overflow (V2 and HPC+ only)
Programming an SR-955? Start here: Programming the SR-955HPC — pick your model and Windows version.This article applies only to SR-955HPC Version 2 and SR-955HPC+ (HPC Plus) radios. The classic SR-...
-
Windows 11 Programming Software Driver
Programming an SR-955? Start here: Programming the SR-955HPC — pick your model and Windows version. The newest Prolific Driver is not compatible with our Programming software. We recommend you r...
-
When is the SR-955HPC Version (V2) going to be available?
The SR-955HPC Version 2 has been available since March 2022. You do not need to wait for it. If you are trying to tell V1, V2, and HPC+ apart (HPC+ is what people call V3), use this page: Which 955...
-
What gauge wire is the SR-447HPC2 power cord?
The factory power cord uses 12 gauge wire. If you need to extend the length of the cord further, use 10- gauge wire. Doing so will ensure that the voltage supply to the radio does not drop. In ca...
-
Center Clarifier Alignment SR-955HPC
Answer Adjust the radio, so it's on frequency. Next, turn the radio off and center the clarifier knobs Turn the radio back on, and everything should be aligned
-
Dimming the display lights on the SR-497HPC
If you push and hold the color button, it will gradually dim the radio. Release the button when you are happy with how dim the lighting on the radio is.