Low Speaker Volume Even With Control Set to Max

Most of the time a jumper wire connector is not completely seated inside your radio. All that needs to be done is remove the bottom cover and push on the white plastic connectors that are on both ends of the wires that run from the front board to the main board. Below is a picture showing the type of connector, you would press them all in, not just those that have an arrow pointing to them.


If this doesn't work please submit an RMA request for warranty repair.





Was this article helpful?
1 out of 1 found this helpful
Have more questions? Submit a request


  • 0
    Chris Rutledge

    I have to do this couple times a year as my radio rids in a log truck and gets bounced around .... volume will get low.... or echo will quit..... take cover off push on all the plugs and good to go

Article is closed for comments.